Repositioning of Needles
Use drill bit to make the hole inside the needle bigger by placing the drill bit in the tube and rotating a few times. You can use a vice grip to hold the drill bit 1mm drill bit
Push needles on lightly then rotate anticlock wise until they are roughly were they started
Speedo gauge : Positon a few millimetres above the white line then rotate antoclockwise to white line rotate and lift over the resting needle point then lift back over the point
Rev counter : as speedo
Fuel gauge few mm below white line , it raises itself on ignition power - but check when back in the car -if you are happy with it then push down fully
Temp gauge: same as fuel gauge
Economy: Roatte few mm below white line by lifting over resting needle then bring back over
|