Clusters on : BMW 5 series X5 E53 7 E38 series

also Range Rover LR322 (similar)

Dial Fitting Changing Main Menu

Fitting your new replacement dial

After removing your existing dial following earlier steps

**Make sure your hands are clean and free of grease/dirt**

1. Clip the new dial into position by pushing it down gently onto the clear plastic light diffuser.
2. Now fit the 2 circular retaining clips using your hands to push down on it , the needle sits over this
3. Next fit needle resting pins - best done by using your finger nails to press down on each side of it. - 3 of these on the BMW but 2 on the LR322 Range.

Phot below: Clear light diffuser before dial fitting

Ready to be fitted

Below: Rear view 

View from rear

Below: Clipped in place ready to push in 2 circular collars

Custom dial fitted to light diffuser

Below: Centre collars and resting pins

Refit circular fittings and needle resting pins

Your next steps maybe:  

1. Fit White/Color LEDS  on PCB ( soldering)
2. go to needle resetting section
3. Refit Torx screws 
4. Check dial for dust / dirt 
5. Clean glass-check for dust / debris on dial or in casing